Built to go drag racing.
Engine:
292 cu in inline 6 cylinder
Built by Mike Kirby at Sissell's Automotive in Covina,CA
Aluminum 12 port cylinder head
Hilborn mechanical fuel injection
12 to 1 comp ratio
Crower cam
Dyno'd at 468 hp at the flywheel on race gas
Chassis:
Original frame, boxed and reinforced
Ladder bar/coil over shocks rear suspension
Heidts front end kit
9" rear end with Moser aluminum carrier and 4.86 gears
Jerico 4 speed trans

Udpate June, 2009
We had the truck out for its first passes down the 1/4 mile at the Gasser Reunion race in Thompson, OH
It ran hard and straight.  I'm still learning how to drive it consistently.
It ran a best of 11.72 at 113 mph.  Not bad for an old truck with an inline 6 cylinder.